Bienvenue sur le site dédié au système d'exploitation alternatif MorphOS.
249 visiteur(s) et 0 membre(s) en ligne.
Connexion
Support
Liens MorphOS
Liens Amiga
Activité du Site
Pages vues depuis 06/01/2019 : 20 123 046
- Nb. de membres 369
- Nb. d'articles 2 969
- Nb. de forums 24
- Nb. de sujets 13
- Nb. de critiques 0
Index du forum »» Démarrage »» [Solved] - Installation on Sam460, requires an ISO as source
[Solved] - Installation on Sam460, requires an ISO as source#2169
1Contributeur(s)
1 Modérateur(s)
Elwood
Hi,
I'm trying to install MOS 3.14 on Sam460 but I can't.
I boot from an SD card and I run the installation procedure. When I select the destination system partition, it says :
"It's required to select an ISO image as a source installation or an absolute path to a MOS CD."
But I can"t select any path anywhere. I just have the "Install" button at the bottom.
What's wrong?
I'm trying to install MOS 3.14 on Sam460 but I can't.
I boot from an SD card and I run the installation procedure. When I select the destination system partition, it says :
"It's required to select an ISO image as a source installation or an absolute path to a MOS CD."
But I can"t select any path anywhere. I just have the "Install" button at the bottom.
What's wrong?
Elwood
Well it works now.
The problem was because I used the OS4 tool to write the MOS hdimg file onto the SD card. Something have gone wrong.
Now I used "dd" on a Linux and it all works. :-)
The problem was because I used the OS4 tool to write the MOS hdimg file onto the SD card. Something have gone wrong.
Now I used "dd" on a Linux and it all works. :-)
This message was edited by : Elwood / 2020-11-22 18:35
